Operation
Like all well-engineered electronics, LDG products are designed with a reasonable safety margin. However, you should never knowingly exceed the limit specif...
Mon, 13 May, 2019 at 1:24 PM
In most cases, no. LDG ‘s advanced tuning algorithms can tune on the fly as you operate, even on SSB or CW. If you have difficulty tuning in SSB or CW, try ...
Mon, 13 May, 2019 at 1:24 PM
Those controls all you to fine tune the match. You probably won t need them very often.
Mon, 13 May, 2019 at 1:24 PM
There is no way to reset all the memories at once. They are overwritten each time you perform a full tuning cycle on the frequency associated with the memor...
Mon, 13 May, 2019 at 1:24 PM
Try resetting the radio as described in the radio manual.
Mon, 13 May, 2019 at 3:00 PM
LDG tuners can match SWR up to 10:1. The SWR on those bands for that antenna could be much higher. You may need a balun or loading coil.
Mon, 13 May, 2019 at 3:01 PM
It s possible that stray RF is getting into the tuner through the radio interface or DC power cable. Try adding some RF chokes to the DC cable going to the ...
Mon, 13 May, 2019 at 3:01 PM
The tuner will re-tune any time the SWR exceeds the threshold limit of about 1.7:1.You can place the tuner in Semi mode to keep it from retuning or increase...
Mon, 13 May, 2019 at 3:01 PM
Your coax length may be an odd wavelength of the frequency that you are trying to tune. Lengthen your coax 3 to 6 feet (1 to 2 meters) on the antenna side r...
Mon, 13 May, 2019 at 3:02 PM
No. The power ratings are for PEP SSB or CW. For 100% duty cycle modes (digital, RTTY, AM) the power limit is about one-third of the power specified. If you...
Mon, 13 May, 2019 at 3:02 PM